摘要:The object of research is the thermal parameters of operation of a fragment of the floor heating system assembled dry, under conditions of actual application set in the lab premises. One of the most problematic issues in the course of our experimental study has turned out to be a small area of the investigated heating system, relative to the volume of the room. Considerable ambient air temperature fluctuations resulted in certain difficulties while the heating system entered the quasi-steady mode.We have established in our study the effect of thickness of a heat insulation layer under the heating circuit on a change in the density of heat flow from the floor surface to the air in a heated room. It is noted that the floor heating system, assembled dry, has small thermal inertia due to the absence of a relatively thick layer of the monolithic concrete slab (with high specific heat capacity), which is typically used for the installation of a heating system circuit.Specifically, it was established that the use of ceramic tiles as the finish coating, compared with laminate, significantly reduces the overall thermal resistance of heat transfer from a heat carrier to the air in a heated room. In this case, the presence of an aluminum heat-scattering plate, which is in direct contact with the outer surface of the pipe in a heating circuit, has a positive effect on the uniformity of distribution of thermal field in the plane of the floor. This in turn leads to a reduction in thermal stresses in the finish coating.Calculations show that the quantitative control over thermal load of such a system by changing the consumption of a heat carrier proves to be less effective than the qualitative control through changing its temperature. Experimental studies reveal that the density of a heat flow on the floor surface increases almost two-fold when using ceramic tiles, in comparison with laminate, at all other thermal system settings being almost identical.The research we conducted make it possible to construct a mathematical model for the operation of a floor heating system, assembled dry, whose application would enable the optimization calculations and improvement of the design of a given heater.
关键词:water floor heating;heating circuit;thermal load;thermal resistance of heat transfer;thermal mode in facilities